Help, GSR rear roll stop mount dimensions

[philsth]

Hi,
I've done a search but could not find the info I need.

Does anyone have a genuine rear roll stop engine mount (must be a mitsubishi mount please) they could measure up for me. This is the mount near the firewall.

I need the measurement from the centre of the mount hole and the base of the mount as shown in attached photo.

I just want to double check the Kelpro mount listed is definately correct.


Thanks
Phil

 

[khubner1]

i just replaced mine i'll measure it up

 

[GSR]

From the center of the hole to the very bottom of the mount like on your picture, its about 42mm.

And from the center of the hole to the rim insert (like on the pic below) its 35mm.



Hope that helps

 

[MISGSR]

I fitted this one

http://www.meek.com.au/index.php?act=viewProd&productId=256

dunno if that helps you much

 

[EVOCPE]

Promoting Bron??

 

[khubner1]

it's the same as 1.8l cc coupe.

 

[philsth]

Thanks all, this measurement is the same as the Kelpro.

Now I can remove the ralliart mounts and replace with softer Kelpro mounts. Once done I intend to sell the mounts (near new) Kelpro frame with Ralliart bush as shown on the MEEK site.

I find the ralliart mounts a bit to stiff and as I wont be racing anymore I'm softening the ride.
KHUBNER can you still send me the dimension please

Thanks Phil.

 

[khubner1]

no prob mate i'll mesure it up after work tomorow

 

[MISGSR]

i only find the feeling when i have a problem elsewhere so i like the Ralliart mounts for that. Free massage at the moment with my std engine mount half dead and loose turbo to manifold bolt and flapping gasket :| . .

You should have no trouble selling the roll stoppers. Specially with the early Ralliart stuff starting to be discontinued.