Injector tuning question

[bazeng]

Jstyle, what are the 800's good for?

I dont want to run out of injectors on the next tune.
Made 300kw's on the last tune remember...
I've been suggested by the yanks that I should go 1000's...

 

[myevo1]

i havent seen anywhere that sells the 1000cc for a decent price
i dont want to buy them from perfectrun

get your prices from perfect run, then go to a shop that you trust and tell them to match the price. I recently did this with some gauges. Found them cheap on the net from America, went into autobarn and made them price match!!


Do bosch make injectors that will fit the 4G63 and are they any good??

 

[JSTYLE]

Jstyle, what are the 800's good for?

I dont want to run out of injectors on the next tune.
Made 300kw's on the last tune remember...
I've been suggested by the yanks that I should go 1000's...

500-550hp at the flywheel

all dependant on:

Fuel Pressure (base pressure and how much boost)
What duty cycle your willing to take those injectors to.

Jon

 

[tharaka]

Jstyle, what are the 800's good for?

I dont want to run out of injectors on the next tune.
Made 300kw's on the last tune remember...
I've been suggested by the yanks that I should go 1000's...

i think once you fix your fuel pressure reg issue, you should be able to make more power before running out of fuel

 

[GVR40]

i got the evo 9 injectors and had them flow tested last week to 610cc, i know its a bit below what you are looking but for under $300 landed at my door from japan i wasn't complainin

 

[brisvr4]

Where did you get yours flow tested Craig?
Sorry to get OT guys

 

[GVR40]

cnj motorsport on kingston road, cost $88, would have been $140 if they needed cleaning as well

 

[JSTYLE]

cnj motorsport on kingston road, cost $88, would have been $140 if they needed cleaning as well

you bought used injectors and only got them flow tested not cleaned? personally i woud of got them cleaned! because you basically reco the injector by using a new internal filter/new seals and orings etc...

and they clean up the spray pattern if there are any issues with that.

Jon

 

[GVR40]

the guys there checked them jon and said they were brand new, and said if they needed to clean them they would but they didn't

 

[tharaka]

lag time on the 800cc SARD is 1.10ms