My 4g63 Sigma

4GTuner

Help Support 4GTuner:

Sig2L

Active Member
Joined
Jan 6, 2010
Messages
28
Hey guys figured i would put a little info about my car, its a 84 GK sigma, bought it as an unfinished project with a 4g63 SOHC. Engine ended up being a terrible slap together job which we realised while pulling down to check its condition, so gave that a freshen up. The turbo that came with it was gone, so bought a new one, finally got it going, good fun. Blew the gearbox first (jap 5 speed) so replaced it with a W57 toyota item, then blew the standard diff and replaced that with a hilux diff with 4.11 and LSD. Going even better again ran a 13.4 at WSID which was a fun street car, well especially for my first turbo car. Ended up blowing the head gasket at the end of the track and decided to stop stuffing around with SOHC and took the car off the road to build a twin cam engine. Got a vr4 bare engine got that rebuilt with Eagle rods, J.E pistons, ARP main, big end and head studs, Removed balance shaft, cometic head gasket. Engine is bolted in now, running a four puck clutch. Waiting on J.M fabrications inlet manifold from the states and the car is booked into get a custom ex manifold at the end of this week. Running T04z 0.7 front and rear. Cant wait to get back on the road, should be fun. Hope ya like it, i know it not an evo but yeah i like going sideways.
 

Attachments

  • front bay.jpg
    front bay.jpg
    38 KB
  • rear outlet.jpg
    rear outlet.jpg
    30.4 KB
  • motor.jpg
    motor.jpg
    35.2 KB
  • Picture 4.jpg
    Picture 4.jpg
    17.2 KB
Welcome!

Love the ride.

I think I may have seen this in a mag once?? Just a small photo with a time and small text..
 
Cheers for the comments people, yeah not too many wires still a bit if a mess, will be good to get everything in and clean it up... I dunno if it has been in a mag, maybe.. I went to wsid about 4 times so there is a chance, would love to see it if you still got it... Cheers
Alex
 
Back
Top