putting injectors in

[MADVR4]

hey has any1 swapped the 450's for 510's??

how hard is it.... i wanna get it done for sat...

gotta redo the maf aswell any help would be cool

cheers!!!!!!!!
grant-

 

[WRCVR4]

hey has any1 swapped the 450's for 510's??

how hard is it.... i wanna get it done for sat...

gotta redo the maf aswell any help would be cool

cheers!!!!!!!!
grant-

Mine were done in a carpark, After i had been fanging around town My poor mate :? Kept burning his fingers :lol:

They arnt hard at all, unclip the connector (wires) undo the bolts for the fuel rail, and they just pop out

New Orings are ALWAYS good :roll:

 

[SIVART]

Grant if you need help just yell out Im not to far away

its really a straight swap over not hard at all

Travis

 

[MADVR4]

wicked shouldnt be that hard anywayz... now i just gotta pray that the ecu gets here in time hehe

cheers lads

 

[rob323]

Please have them flow tested prior to installing them. When I got my 510's, I had them flowed, 3 were perfect, one was 25% down on flow. Could have caused some nasty problems.

 

[MADVR4]

i put them in last night... didnt get flow tested but they were my brothers evo ones..... and they were fine in that so i would assume they are fine still..... yay now just gotta finish cooler piping tommoz night... and get the maf wired up and the ecu to arrive

cheers lads
grant-

 

[JSTYLE]

where they straight out of alex's car or have they been sitting around for awhile?

Jon

 

[MADVR4]

been sitting around for awhile but should be fine

i hope lol i should be able to run the car in for a few days b4 sat see how it goes... if they are **** ill get them done

cheers

 

[JSTYLE]

been sitting around for awhile but should be fine

i hope lol i should be able to run the car in for a few days b4 sat see how it goes... if they are **** ill get them done

cheers

If they have been sitting around for a while, you better pull them out and get them cleaned. No doubt the injector seals on the inside would of dried up and you risk detonating/damaging your motor.

If your going to run them, watch out for knock and also check your spark plugs regularily! But if i was you id get them cleaned before you wind the boost up.

Jon

 

[rob323]

It will only cost about $50 to have them flowed, this will tell you whether any are in need of attention, small price to pay for peace of mind.