RVR in to CB?

[noisy toy]

Hi all. My first post here, awesome site. I have an RVR 4G63T AWD front cut. engine is on passenger side. I am looking at a 1990 Lancer 4 door, considering this car for an AWD conversion. I searched a few forums, sorry if this has been discussed before. My question is, is it a fairly straight forward conversion? I know the rear diff mounts will be a lot of work, but is the front part the same? Can i fit the RVR X-Member? Any tips much appreciated, or direct me to the right place.
cheers, shane

 

[MrConsistent]

If that is the cb or early cc lancer then the the mounts left and right are fine, the front and rear engine mounts are harder. when I put the evo3 engine in my cb and wend awd I needed to modify the n/s brace and make it work for the rear point (just under the firewall) and cut and move the bolt through tube sections in the rad support bracket.

Even the front section will be hard if you do not have someone that is great with metalwork and welding.

Then I grafted the whole rear floorpan from the E3 into mine to make it stronger and this was easier than stuffing around making the mounts for a diff.....
It is possible but I would not recommend it.....