where the fizzle does this hizzle go?

4GTuner

Help Support 4GTuner:

kayarubin

4G63-T
Joined
Dec 30, 2005
Messages
544
just wondering where this vaccum outlet is supposed to go?........ feelin a little gangsta today!...lol

pic! :D
 
also would it be right to run the second crank case vent to that attachment?...u no the one that goes to the pipe before the turbo....

or would it be ***** coz of the pressure of the turbo pushin the air back into the crank case???.... :?

cheers!
 
no, it wont be good, u dont want to boost up your crack case with your turbo..

the pcv has a one way valve that works only at idle, when it boosts, it closes..

that nipple is for your bov
 
im running a T piece up to that nipple.... i am running the turbo actuator to it... and then it goes somewhere else aswell.... is it bad that my actuator is running to it???

cheers
 
u should always run the actuator off a pressure only line... not pressure / vac...

the reason is, due to most actuators running bleed valves, u dont want to be bleeding your bov or fuel pressure reg, u'd only want to be bleeding your actuator line...

your turbo out pipe should have a nipple on it for your actuator..
 
i just realized as i walked off from writing this post that the nipple was for the BOV.....im so thick sometimes!... :?

oh and does anyone have like a....diagram of the different vac/pressure lines and where they go??

sorta like the wiring diagram type layout??

cheers!! :D
 
thats the one i was lookin 4!!

but do you know what those lines are that go back under the inlet manifold are for? is it something important?? or can i just leave it off?

heres a couple pics! :)

cheeeers!
 
one of them is fuel pressure one, and the other is the cyclone, it hooks up to pin 53 on the vr4 ecu

just follow the vacc lines, there should be color lines on them
 
Back
Top