WTB: EVO 1-3 cylinder head

[ENGINR]

Am chasing an EVO1-3 cylinder head for my rebuild. Must be in excellent condition, does not need to include cams, valves etc (but won't knock back if it does!)

Cheers

 

[Rockabilly]

Get a Hyundai Sonata 93 up. Use their inlet mani or there is just a
bit to grind in the corners to match an Evo inlet mani.

 

[kayarubin]

hey mate i have a galant VR4 head with a couple of bent valves in it....but the rest of it is fine......ill have a look when i get home but it should be all good! i can pull the valves out if u want....but yeah! i have no use for it! cheers!

 

[Rockabilly]

ENGINR is after a small port head, not a large port vr4 head.

 

[kayarubin]

oh....oh ok then....whats rong with larger ports...lol

 

[ENGINR]

Heya,

Am interested in the 93 Sonata head, I am going to match it upto an EVO3 inlet mani, on a VR4 block (yeah I know it'll need the head bolt holes enlarged from 11 to 12mm) but how do I run the turbo oil-line outlet from the Sonata head? Is there anything else that the EVO head would have over the Sonata head that I would need to do (apart from the aforementioned grinding)?

Rockabilly - PM sent.

 

[Rockabilly]

PM sent. Only a small amount of grinding in the top corners of the
inlet ports. Throw new valve seals in & minimum surface deck it.
$150 at the wreckers Shayne.

 

[CHEMICAL]

ii got a mint evo3 head here brought it for $1700 nz just had been recond

ill try get specs of recon if interested

 

[ENGINR]

Sounds good but $1700 is a bit more than I was hoping to spend