WTB: GVR4 Gearbox Input Shaft

[MDK87]

Hi guys,

Does anyone have a spare input shaft lying around out of a W5M33 3.545 gearbox that they would be willing to sell me, and post via express?
The ID mark on it would need to be the same as mine, - notches/grooves machined midway on the peak of each and every tooth of first gear. (Sorry thats the best I can explain it, and I can't take a photo atm).
1st gear - 13 teeth
2nd gear - 19 teeth

This particular shaft has proved to be very hard to find. :evil:
Any help would be greatly appreciated.

Note: Obviously it needs to be in good condition......see the problem with mine is, it has a nick in it right where the oil seal goes. Looks like someone done it trying to get the bearing off.

Thanks for reading.

 

[Entaran]

Call me tomorrow and I'll go out into the shed and check. I have 5 shafts, fucked if I can remember what's from what.

0407 569 651. - Lawrence.

If you don't call, I won't remember.

 

[jdm-vr4]

i'll remind him Lawrence

he needs this thing going

 

[blackvr]

Mahommad, I just got your PM. I reckon I have a couple at home. I will check when I get home tonight.

Cheers Mike

 

[blackvr]

OK.. I have heaps of input shafts without the groove. Of these there are two types ... The only shaft I have with grooves is an Evo 1, and that has 14 teeth on 1st gear ie same as Evo RS. Are you sure you cant use a non grooved input shaft ? Or consider resleeving the seal surface that has been nicked. I get Albins in Ballarat to resleeve various shafts. They seem to turn around relatively quickly.

Otherwise, PM some photos to me .

Cheers Mike

 

[jdm-vr4]

Hey guys i'm writing on begahl of MDK87 to tell you guys that the doesn't need that input shaft anymore so mods you can close the post.

cheers