WTB: Rvr / evo 1-2-3 (manual) wiring loom and ecu

[FiEND]

After rvr / evo 1-2-3 wiring loom and ecu to suit manual gearbox.

Or alternatively ecu pinout diagram, which i can't seem to find..

Thanks in advance .

 

[EVO-00X]

How can you miss it lol... Click this link and look 4 sticky posts down: http://4gtuner.com/site/forumdisplay.php?f=26 . Good to see people using it lol

 

[FiEND]

How can you miss it lol... Click this link and look 4 sticky posts down: http://4gtuner.com/site/forumdisplay.php?f=26 . Good to see people using it lol

Thanks mate, however i didn't miss that post, on the contrary i've been through most of them related to that engine in the last 2 weeks.

Problem is that i can't find a diagram indicating where the wires go to and or if they split to somewhere else and or if they come back to the ecu with a different voltage or resistance.

Eg. I've got the CAS sending voltage into the 10 pin (if i recall correctly) white plug that goes behind the center console , just behind the headunit (in the lancers), but i have no idea if that plug wiring is the same for an rvr automatic.

As a consequence i'm not getting spark nor injector signal, so i have no idea where to go from here.

That's what i hunting for, some sort of a wiring diagram where i can see where wires go to, from the ecu into the wiring loom and if it there's different resistance / voltage changes along the way.

 

[ENGINR]

I thought an ECU pinout diagram had been sticki'ed on this forum?

 

[FiEND]

I thought an ECU pinout diagram had been sticki'ed on this forum?

Ugh .. yes they have, unfortunately none of them we're suitable for Rvr .. Which i would've thought had the same pinout as an evo .

 

[wizardofoz]

http://www.evocrew.com/forum/...may help