hey guys, i bought a new clutch and gearbox and ive finally finished putting it in around working and fuckups...
well everythings on right.. i turn on the ignition i9 hear the starter motor sound but its not turning the motor over, seems to be the motor isnt engaging on the flywheel..
now what ive used is a hg galant gsr box on my hh galant engine.. now i figured out the bell housing was different so i had to hack the backplate to make the started motor fit and it doesnt work...
did the starter motor change from hg to hh? if so ill just go past a wreckers and get a hg starter motor and it should be all good right?
help plz as im dying to drive my car again..
ive also been playting round with the height sensor rods on the ecs system and ive made the computer think its higher then it actually is so it goes lower.. quite cool actually
well everythings on right.. i turn on the ignition i9 hear the starter motor sound but its not turning the motor over, seems to be the motor isnt engaging on the flywheel..
now what ive used is a hg galant gsr box on my hh galant engine.. now i figured out the bell housing was different so i had to hack the backplate to make the started motor fit and it doesnt work...
did the starter motor change from hg to hh? if so ill just go past a wreckers and get a hg starter motor and it should be all good right?
help plz as im dying to drive my car again..
ive also been playting round with the height sensor rods on the ecs system and ive made the computer think its higher then it actually is so it goes lower.. quite cool actually