im selling my microtech ecu thats out of my 4G63 "VR4" cos ive upgraded to haltech..
550 ono. any question i will probley have to get back to you cos will have to ask hisham for tenagah..
its a Microtech MT8 Sequential Fire v2.0. Comes with built in map sensor but I'm not sure how many bar, i'm assuming it will be atleast 2 bar, possibly 3 bar? The hand-controller is on your glove-box, dont think you have a laptop connector tho'?
The ecu has a flying lead loom thats wired into your factory loom, so when its chopped off there will be approximately 50-60cm of loom left-over on the Microtech. The Microtech is currently tuned for your car's specs; 4G63 DOHC motor, 750cc injectors running U98ron fuel, Garret GT30 turbo. Dont think there's a base map, but I'm sure its not hard to source a base map for most different cars?
Edit/Delete Message
550 ono. any question i will probley have to get back to you cos will have to ask hisham for tenagah..
its a Microtech MT8 Sequential Fire v2.0. Comes with built in map sensor but I'm not sure how many bar, i'm assuming it will be atleast 2 bar, possibly 3 bar? The hand-controller is on your glove-box, dont think you have a laptop connector tho'?
The ecu has a flying lead loom thats wired into your factory loom, so when its chopped off there will be approximately 50-60cm of loom left-over on the Microtech. The Microtech is currently tuned for your car's specs; 4G63 DOHC motor, 750cc injectors running U98ron fuel, Garret GT30 turbo. Dont think there's a base map, but I'm sure its not hard to source a base map for most different cars?
Edit/Delete Message
