RVR HSGR with vr4 long block.

4GTuner

Help Support 4GTuner:

RVRHSG

Well-Known Member
Joined
Apr 8, 2016
Messages
51
Location
Perth
Just need some advice before swapping in a VR4 long block into hsgr, I will be using back the rvr awd gearbox/transfer case.

-So far I'm aware that the rvr's engine bay CAS wires/connectors need to be change to work with vr4 CAS on the intake camshaft end.
-Swap in a rvr thermostat housing/cover into the vr4 head.
-ecu change to the evo 1-3, mdl510 inctors, either a magna 055/609 maf.

For the flywheel and clutch/disc setup, what 6 bolts flywheel do I need to use? awd? fwd? flat?

Anything else that I'm missing for the above conversion? Please advise accordingly. Thanks!

Wae.
 
I think that the flywheel will be fine, awd are stepped whereas the fwd is flat. I'm not familiar with RVR passenger side mount. You may need to change that over. Other than that I think you have it covered and if you are going to do the mount, may as well throw a water pump and new belts on.
 
Yeh will get the passenger side mount sorted out.

Currently the vr4 long block doesn't have a flywheel, can I use either the 6 bolts oem vr4 awd flywheel or need to use a 6 bolts fwd flywheel (from what vechile)?
 
Back
Top