K33P_UP
Black CE9A Evo III
Hey guys,
I was speaking to a mate of mine about transfer cases, as I think the rear seal on mine is rooted (lots of oil on the tail shaft and floor pan, I will find out this week if it is the trasnfer case). He mentioned something about getting Polyurethane or Solid engine mounts because when I give it some stick my motor would be lifting up and it pulls the tail shaft out of the transfer case (just a bit, enough to wear it out over time). Can anyone clarify if this can happen and if Polyurethane engine mounts can prevent the rear seal on the trasnfer case from blowing out?
I was speaking to a mate of mine about transfer cases, as I think the rear seal on mine is rooted (lots of oil on the tail shaft and floor pan, I will find out this week if it is the trasnfer case). He mentioned something about getting Polyurethane or Solid engine mounts because when I give it some stick my motor would be lifting up and it pulls the tail shaft out of the transfer case (just a bit, enough to wear it out over time). Can anyone clarify if this can happen and if Polyurethane engine mounts can prevent the rear seal on the trasnfer case from blowing out?