Search results

Sorted!

I vote option 4, the only one that mentions topless waitresses!

price drop, $10,000.

still up for sale guys...

damn, how'd you get away with 6k for a forged rebuild? I got new cooler, piping, clutch, forged internals, cams/cam gears, injectors etc and spent a fair bit more than 6k.

i'll be up for that... when?

ran it down the quarter yesterday, managed a 13.3. with a bit of tuning should easily see a 12. Cheers, BennyG

Sorry Guys... $12,000.

Guys, Car - 1992 A-Spec Galant VR4 with 225,000km's (fully rebuilt at 200,000km's) Engine Mods - Fully rebuilt 4G63, forged pistons and rods, balanced bottom end, jim berry 4 puk button clutch, heavy duty valve springs, Crower 272/272 camshafts, 3g revised lifters installed, adjustable cam...

I'll be in for this guys, only new to Melbourne so be good to meet you all! Cheers, BennyG

cheers Baz! sorry only read this now so obviously won't be able to test the intake today, but i'll chat with you by pm and organise another time... and both front cv's are making noise, the front passenger is the worst, so was just going to look at replacing it. Cheers, BennyG

Hey guys, New to Melbourne. Firstly, Anyone have any suggestions for driveline shops (replace CV's etc.)...? Also, Do we have a 'Chiptorque' down here? I have a chiptorque chip in my car that i'd like to get re-tuned. Finally, do any of you guys have a 'pressure test' setup, so i can...

Guys, Car - 1992 A-Spec Galant VR4 with 218,000km's (fully rebuilt at 200,000km's) Engine Mods - Fully rebuilt 4G63, forged pistons and rods, balanced bottom end, jim berry 4 puk button clutch, heavy duty valve springs, Crower 272/272 camshafts, 3g revised lifters installed, adjustable cam...

thanks for the link, i have already emailed bimmubishi to try and get info aswell. i just want info on general problems i will run into, major costs etc. i'm aware i'll have to modify the intake to enter from the opposite end, and get a turbo off an evo 4+, and can get a bellhousing adapter...

Hey guys, Just looking into putting a 4g63 into an e30 bmw... just wondering if anyone had looked at doing similar, or could help out with any info! Probably be looking at doing a 2.3L stroker with big cams, td06 20g, supra gearbox with rear lsd... should be good fun! Cheers. Ben

im sure you can reduce it, it just says 'increase' on the web site because 99.99 percent of people would want to increase, not decrease...

broke my leg and tore tendons in my knee wakeboarding 18 months ago... not a fun experience, all of a sudden it became a LOT harder to get the board off! and then, because they didn't want to ruin the day, i lay in the back of the boat with ice for the next few hours, before being taken to...

as you can see from those pics, j spec bar is slightly lower (has cut out for exhaust), whilst a spec is above exhaust.

there is a little plug on the left hand side of the engine, just above where the bellhousing bolts on, and the wire that plugs into it controls the thermo fans when the car gets to a certain temp. if that wire is earthed out (as mine is, on purpose), then both thermo's run flat out, all the...

ok will do $500 including freight for intercooler, all piping, clamps, silicone & bov. lowest i will go. complete kit! cheers, Ben