Evo 3 to RVR ECU pinout

[Taz]

Hey guys,
I recently just purchased an Evo 3 ecu with ECMlink to put into my 97 hypergear and was curious if the pinout is the same or it is straight plug and play. I had to swap the ECU case as they mount differently but still bolts in and plugs in fine after that so only thing that could trip me up is a different pin out if any.
Anyone done this or know if they are?
Also have a MAP conversion cable for an earlier model mitsi as my plug is different - smaller than the one supplied. By some miracle is there a known adaptor plug/cable to make this plug and plag or am i splicing plugs? (see pic for comparison)
TIA

 

[Taz]

Guess i had a moment with the MAF plug - ill just buy the correct cable from ECMlink as its a genuine cable and they sell 2G cables for 55 bucks... :blush: :blush:

 

[4piknup]

I got some of those 3g afm plugs with pigtails. Can't recall from where, but they are/were available.

 

[4piknup]

https://www.extremepsi.com/store/2g-DSM-Mass-Air-Sensor-Harness-to-3g-Evo-Air-Flow-Sensor-MAF-Cable-Adapter-MAF-Connector.html

I think this is the cable...
You could also get that 3g plug from a later mitsi, and wire it up.

If getting stuff from ECM link, maybe get a SD cable as well, for future tuning.