GSR/Evo engine mounts

4GTuner

Help Support 4GTuner:

jack be nimble said:
Get some mad Polly inserts. Available from for sale pages.
Do they have a thread on here somewhere, or do I have to PM someone? I can't find a sale thread.

**EDIT**

All good. Found it.
 
Chasing confirmation on dimensions for GSR engine mounts

Front: 80mm x 40mm
Left/Right: 80mm x 50mm
Rear:70mm x 40mm

Is this right? I bought a set of madpoly bushes, but none fit. I just want to check the dimensions are right.

I have contacted madpoly, just want to check to make sure I was sent the right sizes.
 
I think it's important to point out the difference between the mad polly instructions above and using the prothane inserts is that you need to remove the metal outer ring (at least on the timing belt mount) when installing the prothane mounts. Polly calls for leaving the ring in. I spent more time than I care to admit cleaning that outer ring, only to find that my prothane mount won't fit when leaving the ring in. I'm also assuming you will need to leave the side cushions on the timing belt mount too.
 
Yea no big deal, I just figured they were left in like mad polly ones, guess not. So I'm assuming that every mount requires the outer ring to be removed for the Prothane inserts.
evo-gsr said:
The reason being is the prothane mounts have a lip around the outer edge...not sure if the madpollys do?
 

Latest posts

Back
Top