something_wild
Well-Known Member
Hi guys,
Recently took the HSG over to Adeliade from Melb for a weekend bucks. Cruised there with zero dramas (first long interstate trip) and was quite comfy...the exhaust silencer helped lol.
Anyway just a small concern I had regarding the oil temp at freeway speeds. I have a digital oil temp gauge that's been installed properly and is reading correctly. Around town it sits between 92-96degrees once completely warm...which takes a good 10-15 mins. But sitting on 100k/h, it would climb over 100oC and settle around 102/104oC, and on 110/115km/h it would climb to 105/107o and during a few good hills and 2-3psi of boost was needed it even peaked at 110oC....I backed off and slowed to below 100km/h and it fell back to the middle figures of 105/6oC.
Is this normal, I don't remember it EVER going over 98oC before my last service even on the freeway. Could it be the oil grade/thickness. The workshop only use Motul but I don't know if they changed grade...?
Any other suggestions? Or anyone know the correct oil temp it should be sitting on. My water temp never changes from low 90's oC...I know that irrelevant but since I have that in a digital read also, It's good to know.
Recently took the HSG over to Adeliade from Melb for a weekend bucks. Cruised there with zero dramas (first long interstate trip) and was quite comfy...the exhaust silencer helped lol.
Anyway just a small concern I had regarding the oil temp at freeway speeds. I have a digital oil temp gauge that's been installed properly and is reading correctly. Around town it sits between 92-96degrees once completely warm...which takes a good 10-15 mins. But sitting on 100k/h, it would climb over 100oC and settle around 102/104oC, and on 110/115km/h it would climb to 105/107o and during a few good hills and 2-3psi of boost was needed it even peaked at 110oC....I backed off and slowed to below 100km/h and it fell back to the middle figures of 105/6oC.
Is this normal, I don't remember it EVER going over 98oC before my last service even on the freeway. Could it be the oil grade/thickness. The workshop only use Motul but I don't know if they changed grade...?
Any other suggestions? Or anyone know the correct oil temp it should be sitting on. My water temp never changes from low 90's oC...I know that irrelevant but since I have that in a digital read also, It's good to know.