wheel fitment

[clone]

Don't have tyres on the rims yet but yeah trial fit the rims against the new 5 stud rear arms I made up and yeah.. They hit . Actually might just press the hub out of the Bearing a few mm to see I it makes a difference lol joke

 

[evo-gsr]

Clone- are these the new rims you bought for a couple of grand, which almost got you divorced?
You won't wanna tell her about that, if that's the case!!

 

[DOUGMO]

ENGINR are you running cc gsr rear control arms with EVO6 OZ rims (17x7.5 +38) ?

late reply, they will clear

 

[clone]

Hahaha .... Yeah they are the wheels lol contemplating putting longer stud and spacers or cutting into the arms and reinforcing behind

 

[evo-gsr]

Shit hey.....Longer studs and spacers would be the best bet, bit safer IMO.

 

[Cranked]

Okay confirmed they are 17x7.5 with offset 42 and the touch the rear arms... Grrr

Odd, because I'm running 18x7.5 +42 and they clear.

 

[clone]

yeahp long story short, they DO FIT HOORAY! MISSIS AINT GOING TO MURDER ME! lol

 

[fi5hGSR]

Bringing back an old thread but will 17 x 8 + 30 fit alright on a Lancer CC GSR? I'm going off this:

http://www.rimtuck.com/setup/view/1205

I might be running a 40 profile instead of the 45 as indicated in the link. I don't want it to poke out too much..

Thanks for you help everyone.

 

[clone]

they fit but will stick out of the gaurds mate

 

[captainTeeBag]

if you go to a 40 series tyre it wont really make it that much narrower than the 45. with an offest of 30 youll be poking quite far out and youll most likely rub alot. what are the wheels you are looking at? can you get 4-5mm machined off the inside?

 

[4piknup]

Then the fronts rub on the rails when turning.

 

[EVOCPE]

I use this

http://www.rimsntires.com/specs.jsp

 

[4piknup]

Nice ↑↑↑

 

[fi5hGSR]

Thanks guys. :thumbsup: