boost actuator and boost bleed valve

[evo-gsr]

Maybe they have fixed the issue that I was reading about. Not saying yours is shit....just giving him some more options.

 

[evo-gsr]

Okay best place to get them?

Straight off their website.

www.maperformance.com

 

[VIN18M]

Probably. Mine was square though, speaking from actual experience.

 

[4piknup]

Best to check regardless. Just need a block and a bit of wetndry

 

[evo-gsr]

Or a steel ruler across the mating face.?

 

[BYBY5L]

Unsure what brand mine is- only a cheapo 1, was only $120 off trademe, was sqaure too, only downside is its fairly obvious it doesnt plumb back in though

 

[svanh1993]

Sorry guys havent been on because we had a category 5 cyclone up here that demolished basically anything in its path with 300kmh winds luckily car was unharmed

And have you got a pick of that one mate and the website by any chance

 

[BYBY5L]

https://touch.trademe.co.nz/motors/listing/view/849892478

dunno who ya were referring to but this is the one I got, just get in contact with them 1st to sort shipping if ya do go with the linked one

 

[evo-gsr]

Or do you mean me? And the one I mentioned?

 

[svanh1993]

Nah mate well cause I'm a boilermaker I was thinking of making one my self out of 12mm stainless and a 3mm wall in about 316 but thinking it may crack as my mates vl TiVo stainless manifold cracked but he runs like 28psi

 

[evo-gsr]

https://touch.trademe.co.nz/motors/listing/view/849892478
dunno who ya were referring to but this is the one I got, just get in contact with them 1st to sort shipping if ya do go with the linked one

These ones are everywhere.....there are people selling similar/same on ebay for much dearer....I actually had one of the ebay ones a while back and it was far from being flat. I had to have the mating surfaces shaved to get it anywhere near being flat.

 

[svanh1993]

Well we have all those machines at my workshop as I'm a boilermaker and have lathes and Miller's for surfacing

 

[BYBY5L]

These ones are everywhere.....there are people selling similar/same on ebay for much dearer....I actually had one of the ebay ones a while back and it was far from being flat. I had to have the mating surfaces shaved to get it anywhere near being flat.

true, tbh I had no real intentions of keeping it on for that long thinking id last a couple of months and get done then take it off for a ported cast one, but 4-5 years on... its still alright!

I must of got lucky cos I remember thinking that its gunna need a shave but when I checked it, turned out to be square!

 

[svanh1993]

Well that's alright then are they like 3mm thick pipe or is it thin

 

[evo-gsr]

true, tbh I had no real intentions of keeping it on for that long thinking id last a couple of months and get done then take it off for a ported cast one, but 4-5 years on... its still alright!
I must of got lucky cos I remember thinking that its gunna need a shave but when I checked it, turned out to be square!

I guess its luck of the draw and depends if it was made early in the week, or on a Friday arvo !!